Sierra Wireless EV-DO User Manual

Page 38

Advertising
background image

Hardware Installation of the PinPoint-E

Rev 3.0B Feb.08

33

Figure 4-1: PinPoint-E Connectors

Antennas selected should not exceed a maximum gain of 5 dBi 
under standard installation configuration. In more complex 
installations (such as those requiring long lengths of cable and/
or multiple connections), it’s imperative that the installer 
follow maximum dBi gain guidelines in accordance with the 
radio communications regulations of the Federal Communica‐
tions Commission (FCC), Industry Canada, or your country’s 
regulatory body (if used outside the US). 

Your PinPoint‐E will work with most Dual‐Band PCS cellular 
antennas with a TNC or SMA (diversity only) connectors that 
work in the high and low frequencies of the cellular 
technology of your modem. Connect the primary antenna or 
primary RF cable directly to the antenna connector on the back 
of the PinPoint‐E.

Tip: When using a cable to an antenna placed away from the
modem, minimize the length of your cable. All gain from a more
advantageous antenna placement can be lost with a long cable to the
modem.

Note: Use of receive diversity for
EV-DO is optional. Data trans-
mission and reception may be
adversely affected if it is not
used.

GPS

Your PinPoint‐E will work with most standard active GPS 
antennas. Connect the GPS antenna or cable directly to the 
threaded SMA connector. 

Mount the GPS Antenna in the vehicle. The less the cable is 
wrapped and bound together, the better it will perform. Place 
it on the roof, or on the dash, or rear panel where it has a good 
view of the sky (greater than a 90 angle view of the sky).

There are three options for antenna mounts:

Magnetic roof‐mount

Through glass‐mount

Permanent mount

To provide for diversity in the signal reception, connect the 
second antenna to the second antenna port (SMA, labeled Rx 
Div) on the back of the PinPoint‐E.

Caution: If you are not using a diversity antenna, you should disable
the receive diversity option. In Ace Manager in the 1x/EV-DO group,
configure *EVDODIVERSITY.

Advertising