Sony Remote Control Panel RCP-D50/D51 - Manual (Page 27)

27
Menu Items with the DXC-D30/D35-Series Cameras
The “Control items” marked with
z
are those assigned
to the control knobs. The other items are operated on
the menu display.
Paint menu (with the DXC-D30/D35 series)
Paint menu consists of pages 1 to 4.
You can select page 1 through 3 directly by pressing
the MENU buttons, PAINT 1, PAINT 2, or PAINT 3.
Pressing v or V of the page selected with a MENU
button flip pages 1 through 4 in sequence.
Page Menu Submenu Control item Function
Paint 1 White White Preset To retrieve the preset white balance settings in the camera
Auto To select the auto white balance adjustment mode
Manual To select the manual white balance adjustment mode
ATW To turn ON/OFF the Auto Tracing White function (which
automatically adjusts the white balance when lighting conditions
change)
• R To adjust the gain for the R signal in the white when Manual is
pressed
• B To adjust the gain for the B signal in the white when Manual is
pressed
Black Auto To select the auto black balance adjustment mode
Manual To select the manual black balance adjustment mode
• R To adjust the gain of the R signal in the black
• B To adjust the gain of the B signal in the black
• Master To adjust the master black
Flare Flare Off To turn the flare (black level when flare is generated) correction
function ON/OFF
• R To adjust the amount of flare correction for the R signal
• G To adjust the amount of flare correction for the G signal
• B To adjust the amount of flare correction for the B signal
Gamma/Knee DL To turn ON/OFF the DynaLatitude function (for automatically
setting the contrast between the bright and dark areas by detecting
the levels of the subject in these areas)
Knee Preset To turn ON/OFF the mode that uses the preset knee correction value
Auto Knee To turn the Auto Knee circuit ON/OFF
• Gamma To adjust the gamma level
• Knee Point To adjust the level at which the knee correction starts. As the value
becomes larger, the start level decreases, which enhances the knee
correction effects.
• Knee Slope To adjust the knee slope (amount of knee correction)
The items displayed differ according to whether the
unit is in Advanced Setting mode or in Normal Setting
mode. The items shaded (
) in the table below are
displayed only in Advanced Setting mode.
Switching between Normal Setting mode and
Advanced Setting mode is performed in RCP Config
(Security
→ Status) on the OTHERS menu.
Paint 4 can also be selected by pressing the PAINT 3
button.