Sony Remote Control Panel RCP-D50/D51 - Manual (Page 56)

56
Skin Detail Correction/Skin Matrix Adjustment (for
DXC-D30/D35/D50 Series Only)
The skin detail and skin matrix functions can adjust
detail level and matrix (saturation and hue) of a
selected skin gate area (area designated by color
range).
Once a skin gate area has been selected, it can be used
as a target for both skin detail correction and skin
matrix adjustment, and activation of each function can
be performed independently.
Selecting the skin gate area
Normally, use the SKIN DTL SETUP button of the
AUTO SETUP block to designate the skin gate
position (target color) automatically.
1
Press and light the SKIN DTL SETUP button
(ON).
The window which shows the skin gate and target
area appears in the camera’s viewfinder.
You can also see the skin gate with a picture
output from the CCU’s PIX connector.
2
Press the START button.
The skin gate is designated automatically.
When using a DXC-D30/D35-series camera, you can
manually adjust the position of the designated skin
gate in Paint menu.
Performing skin detail correction
By skin detail correction, you can lower the detail level
of the skin gate area to the detail level outside of the
area.
1
Press and light the SKIN DETAIL button (ON).
2
Select [Skin Detail] in Paint menu 2.
3
Set the detail correction level using the leftmost
control knob (Level).
Setting the level to the max. value (+99): The
detail level of the area is set to the lowest level.
Setting the level to the min. value (0): The detail
level of the area is set to the same level with the
outside of the area. (The same situation as the
skin detail function is set to off.)
If you power off the unit or store the current
settings as a scene file while setting the detail level
to the minimum value, the skin detail function will
be set to off when you power on the unit or recall
the scene file next time.
To store the skin detail settings
Set the SKIN DETAIL button on before powering off
the unit or storing the settings as a scene file. If the
button is off, the skin detail settings will not be stored.
Performing skin matrix adjustment
Follow the procedure described below to adjust the
matrix (saturation and hue) of the skin gate area.
1
Select [Skin Matrix] in Paint menu 3.
2
Set [Skin Matrix] to ON.
3
Set the saturation and hue using the leftmost
control knob (Hue) or the second control knob
(Sat) from the left.
Selecting 00 causes the same situation as the skin
matrix function is set off.
If you power off the unit or store the current
settings as a scene file while selecting 00, the skin
matrix function will be set to off when you power
on the unit or recall the scene file next time.
Note
When using the DXC-D30 series, this adjustment is
valid when the matrix adjustment function is active.
To store the skin matrix settings
Activate both the matrix adjustment and skin matrix
adjustment functions before powering off the unit or
storing the settings as a scene file. Otherwise, the skin
matrix settings will not be stored.