Sharp UX-460 - Manual (Page 44)

STOP
Fax reception on TAD failure
If the memory for recording incoming messages becomes full while
you are out, the answering machine will no longer be able to record
messages. The ON TAD FAILURE setting is used to choose the
response of the machine to incoming calls when this happens:
♦
Automatic fax reception NO: The UX-460 will answer after 20
rings, after which it will wait to receive a remote command. Most
callers will hang up before it answers; however, when you call the
UX-460 from a remote location, you can wait until it answers,
listen to your messages, and then erase them (see Remote
Operations in this chapter).
♦
Automatic fax reception YES: The reception mode will switch to
FAX mode, allowing the UX-460 to continue to receive faxes
automatically. With this setting, you can still use the remote
commands to listen to your messages and erase the message
memory (see Remote Operations in this chapter).
Automatic fax reception is set to NO at the factory before shipping. If
you want to set it to YES, press the panel keys as follows:
1
Press these keys:
The display will show: T.A.D. SETTINGS
2
Press these keys:
The display will show: ON TAD FAILURE
3
Press 1 to turn automatic fax reception
on, or 2 to turn it off.
4
Press the STOP key.
or
FUNCTION
0
1 2
Optional Answering Machine Settings
42