Sharp UX-460 - Manual (Page 56)

••
Repeat playback: To listen to your
messages again, press "7" and "#".
••
Perform other operations: You
can enter any of the commands
described in the following section,
Other remote operations.
••
Hang up: If you do not erase your
messages first, they will be saved
and any new messages will be
recorded after them. If you want the
UX-460 to resume normal operation
immediately, press "
*" twice
before hanging up (in some cases,
particularly when the Transfer
function is used, the UX-460 may
not accept new calls for one or two
minutes after you hang up unless
you first press "
*" twice).
Comments:
••
When a remote command is accepted by the machine, you will hear one beep.
If an incorrect command is entered, you will hear four beeps. In the latter
case, re-enter the correct command.
••
When entering a command, do not pause longer than 10 seconds between
each digit. If you do, a 4-beep error signal will be issued and the digits
entered up to that point will be disregarded. In this case, re-enter the
command from the beginning.
••
If you make two errors (causing two 4-beep signals to be issued) while
entering your remote code number, the line will be disconnected. This
prevents unauthorized people from attempting to guess your remote code
number.
••
If you pause for longer than 10 seconds before entering a command, you will
be disconnected.
7
Remote Operations
54