Sharp UX-460 - Manual (Page 54)

Retrieving your messages
Note: You can also access the UX-460 for remote operation when the
reception mode is set to FAX. In this case, call the UX-460, press the "#"
key immediately after it answers (before you hear the fax tone), and then
continue from Step 2 below.
1
Call the UX-460 from a touch-tone
telephone. When your outgoing
message begins, press the "#" key on
the telephone.
••
You will hear a short beep, and the
outgoing message will stop.
2
Enter your remote code number and
then # by pressing the keys on the
telephone.
••
You will hear a series of beeps
equal to the number of messages
recorded, or one long beep if four or
more messages have been received.
The machine will then play back the
messages, beeping once at the end
of each message. When all
messages have been played back,
you will hear a long beep.
••
If no messages have been received,
you will hear a short beep. You can
either hang up, or perform any of
the operations described in the
following section Other remote
operations.
2
(Example)
2 2
Remote Operations
52