Secure Computing SSL Scanner - Manual (Page 119)

Common
—
Add to Dimension Filter List
After specifying the dimensions settings in the way described above,
click on this button to add them to the list.
This addition will be valid only under the policy you are currently con-
figuring.
To add dimensions to the list for all policies, mark the checkbox labeled
Add to all policies
before clicking on the button.
If dimension settings that were configured under another policy are al-
ready in the list, the setting of the
Add to all policies
checkbox will
have no effect.
The Dimension Filter List is displayed at the bottom of this section.
To display only a particular number of list entries at a time, type this number
in the input field labeled
Number of entries per page
and enter it using the
Enter
key of your keyboard.
If the number of entries is higher than this number, the remaining entries are
shown on successive pages. A page indicator is then displayed, where you
can select a particular page by clicking on the appropriate arrow symbols.
To edit an entry, type the appropriate pixel values in the corresponding input
field and mark or clear the
deactivate
checkbox in the same line.
Then click on
Apply Changes
to make these settings effective. You can edit
more than one entry and make the changes effective in one go.
Use the following items to perform other activities relating to the list:
•
Filter
Type a filter expression in this input field and enter it using the
Enter
key
of your keyboard. The list will then display only entries matching the filter.
•
Delete Selected
Select the entry you wish to delete by marking the
Select
checkbox next
to it and click on this button. You can delete more than one entry in one go.
To delete all entries, mark the
Select all
checkbox and click on this button.
3–49