Secure Computing SSL Scanner - Manual (Page 13)

Introduction
The click history is only recorded for the current session, i. e. until you log out.
After logging in for a new session, the recording of tabs and paths will start all
over again.
Information Update
Some parts of the information that is provided on the tabs of the Web interface
will change from time to time. In these cases, the information display is updated
automatically every three seconds by Webwasher.
So, e. g. you might have performed a manual update of the anti-virus engines.
This means that the information provided in the
Current Status
and
Log File
Content
sections on the corresponding
AV Engine
tab will begin to change
continuously over a certain period of time until the update is completed.
These sections are then updated automatically every three seconds to reflect
the status of the update process.
Logout
To logout from a Webwasher session, click on the
logout
link, which is located
in middle position at the top of the Web interface area.
After logging out, the login page is displayed, where you can login again and
start a new session.
Main Feature Enabling
There are Webwasher settings that cannot only be modified if a corresponding
main feature is disabled. So, e. g. if you want to modify the settings of the
Phishing Filter
section on the
Settings
tab under
Anti-Spam > Message
Filters
, you need to make sure the
Message Filter
feature itself is also en-
abled.
If you attempt to modify settings while the corresponding main feature is not
enabled, an alert is displayed to make you aware of this situation:
1–9