Socket Mobile Bluetooth iPAQ - Manual (Page 60)

60
STEP 9: S CAN D ATA INTO Y OUR A PPLICATION
1. Press the trigger button and scan the barcode. For example, try scanning
the barcode below:
Note: After data is read and sent to the device, the Bluetooth CHS will beep
once, the LED will flash green, and the beam will turn off.
Note: If no data is read in a few seconds, the scanner beam will turn off, and
you must try again.
2. After a successful scan, data should appear in your document. The default
“CR” (carriage return) suffix will advance the cursor to the next line or
field, ready for the next scan.
SocketScan Auto-Reconnect
The scanner will disconnect if it is powered off or moves out of the
connection range. If the scanner is powered back on or returns back in range
within 3 minutes after disconnection, SocketScan will automatically attempt
re-connection.
• Failure to reconnect will cause the scanner to end auto-reconnect mode
and disconnect. You will then be required to make a connection manually
through SocketScan by tapping on the SocketScan icon and tapping
Connect CS.
• A manual connection will also be required if the scanner is not powered
back on or does not return back in connection range within 3 minutes
after a disconnection.
• A connection remains when the smartphone device is in suspend mode.
Note: By default, CS Auto Power off mode is enabled. This mode must be disabled
for automatic reconnections.