Star Micronics PCI/ISA System Board D6-IN - Manual (Page 28)

D6-IN System Board Manual
Chapter 4: The BIOS Setup Utility
26
After the system is turned on and goes through a memory
test, the Power-Up screen (Figure 4-1) will appear on
your monitor:
Figure 4-1: Power-Up Screen
When “Press <F2> to enter SETUP” appears at the
bottom of the screen, press the <F2> key to begin the
Setup procedure. The CMOS Main Screen (Figure 4-2)
should appear and the prompt should be on the time
line. The Setup procedure can only be activated during
the boot sequence.