Star Micronics PCI/ISA System Board D6-IN - Manual (Page 38)

D6-IN System Board Manual
Chapter 4: The BIOS Setup Utility
36
Set Supervisor Password
Press the ENTER key to enter the Supervisor Pass-
word submenu.
Type the password and press the ENTER key. Retype
the password and press the ENTER key again. Write
down the password somewhere safe so it will not be
forgotten. The password may be disabled by setting the
new password to nothing (pressing the ENTER key
without first typing a password).
WARNING: If you forget the Supervisor Password, it
cannot be disabled without discharging the CMOS.
Set User Password
Follow the same procedure used to set the Supervisor
Password.
NOTE: After a password is entered, it is saved immedi-
ately. All other changes may still be discarded (see Exit
Screen).
Figure 4-6: Supervisor Password Submenu