StarTech.com CONYX ECS0016 - Manual (Page 11)

Instruction Manual
4
ARPPing IP Address Assignment
If it is not convenient to change the PC/workstation network address, you
can use the ARP-Ping command to reset the ECS0016 IP address. To do
this from a Windows PC:
Click 1. Start > Run
Type 2. cmd in the text box provided and click OK to open the command
line
Type 3. arp –d to flush the ARP cache:
Type 4. arp –a to view the current ARP cache which should now be
empty.
Now, add a static entry to the ARP table and ping the ECS0016 to
prompt it to assume the IP address.
The following example illustrates an ECS0016 with a MAC Address
00:13:C6:00:02:0F (designated on the label on the bottom of the unit),
and we are setting its IP address to 192.168.100.23. Also, the PC/work
station issuing the
arp command must be on the same network
segment as the ECS0016 (i.e. have an IP address of 192.168.100.xxx).
Type 5. arp -s 192.168.100.23 00-13-C6-00-02-0F (Note for UNIX the
syntax is: arp -s 192.168.100.23 00:13:C6:00:02:0F)
Type 6. ping -t 192.18.100.23 to start a continuous ping to the new IP
Address.
Turn on the ECS0016 and wait for it to configure itself with the new IP 7.
Address. It will start replying to the ping at this point.
Type 8. arp –d to flush the ARP cache again.
Activate your preferred browser on the connected PC/ workstation and 9.
enter
https://192.168.0.1 in the URL field.