StarTech.com CONYX ECS0016 - Manual (Page 15)

Instruction Manual
8
By default the ECS0016 LAN port auto detects the Ethernet connection
speed. However you can use the
Media menu to lock the Ethernet to 10
Mb/s or 100Mb/s and to Full Duplex (FD) or Half Duplex (HD).
Click 4. Apply. You will need to reconnect the browser on the PC /
workstation that is connected to the ECS0016, by entering http://new
IP address .
System Services
The Administrator can access and configure the ECS0016 gateway using
a range of access protocols. The factory default enables HTTPS and SSH
access and disables HTTP and Telnet. The Administrator can simply dis-
able any of the services, or enable others.
Select the System: Services option then select /deselect for the service
to be enabled /disabled. The following access protocol options are avail-
able:
Please note: If you have changed the ECS0016 IP address, you may
need to reconfigure your PC/workstation so it has an IP address that is
in the same network range as this new address (as detailed in an earlier
note in this chapter).