Samsung MUXONENAND A-DIE KFM2G16Q2A - Manual (Page 88)

MuxOneNAND2G(KFM2G16Q2A-DEBx)
- 88 -
FLASH MEMORY
MuxOneNAND4G(KFN4G16Q2A-DEBx)
3.4.3.1 Unlocked NAND Array Write Protection State
An Unlocked block can be programmed or erased. The status of an unlocked block can be changed to locked or locked-tight using the appro-
priate software command. (locked-tight state can be achieved via lock-tight command which follows lock command)
Only one block can be released from lock state to unlock state with Unlock command and addresses. The unlocked block can be changed
with new lock command. Therefore, each block has its own lock/unlock/lock-tight state.
If any blocks are changed to locked-tight state, the all block unlock command will fail. In order to use all block unlock command again, a cold
reset is needed.
3.4.3.2 Locked NAND Array Write Protection State
A Locked block cannot be programmed or erased. All blocks default to a locked state following a Cold or Warm Reset. Unlocked blocks can be
changed to locked using the Lock block command. The status of a locked block can be changed to unlocked or locked-tight using the appro-
priate software command.
Unlock Command Sequence:
Start block address+Unlock block command (0023h)
Unlocked
All Block Unlock Command Sequence:
Start block address(000h)+All Block Unlock command (0027h)
NOTE :
Even though SBA is fixed to 000h, Unlock will be done for all-
block.
Unlocked
Lock Command Sequence:
Start block address+Lock block command (002Ah)
Locked