Samsung MINI SMART SCC-C7325 - Manual (Page 28)

28 – 10X MINI SMART DOME CAMERA
How to use OSD Menu
AUTO PAN SETUP
Up to 8 Auto Pans are available, which makes
camera to move slowly between two preset points.
PATTERN SETUP
Up to 4 patterns can be stored in the dome.
In this function, path data created by manual move
of Joystick are recorded and you can playback the
identical path automatically whenever required.
SCAN SETUP
Up to 8 Scans can be defi ned.
In a Scan, max 20 entities are assigned from any
combinations of Preset/Auto Pan/Pattern. If you run
a Scan, camera will execute each entry sequentially.
SCHEDULE SETUP
7 rules of Schedule can be assigned by day and
time. Appropriate actions (such as Home, Preset,
Auto Pan, Pattern and Scan) can be defi ned for
each rule. Also, it is possible to use Weekday and
Weekend in a rule to make it simple.
PRESET SETUP
PRESET SETUP
PRESET NO. 1
<EDIT SCENE>
<LABEL>
NORTH GATE
CLR PRESET CANCEL
CAM ADJUST GENERAL
ALARM OUT -
BACK
EXIT
PRESET Number [1~128]
If a selected preset is already defi ned, camera moves
to pre-defi ned position and preset characteristics
such as Label and Relay Outputs show on monitor.
If a selected preset is not defi ned, “UNDEFINED”
shows on monitor.
EDIT PRESET SCENE
Redefi ne current Preset scene position (i.e. PTZ).
EDIT PRESET LABEL
Edits Label to show on monitor when preset runs.
MAX. 10 alphabets are allowed.
CLEAR PRESET [CANCEL/OK]
Delete current Preset data
•
•
•
•
•
•
•
•
CAM ADJUST [GENERAL/SPECIAL]
WB(White Balance) and AE(Auto Exposure) can
be set up independently for each preset. There are
2 modes, “General” mode & “Special” mode. The
General mode means that WB or AE can be set up
globally for all presets in “CAMERA SETUP” menu.
The Special mode means that WB or AE can be set
up independently or separately for each preset in
each preset setup menu. Each Special WB/AE value
will be applied when camera arrives to the preset
location. During jog operation, General WB/AE value
should be applied.
All Special WB/AE value will not be affected by
General WB/AE value changes. If “Special’’ is
selected, Menu to set WB/AE shows on monitor.
Its default is GENERAL.
ALARM OUT
Relay Output can be linked with Preset run.
The character“-“means disable while the number “1”
representing each bit means ON.
Ex) If it is set to “1”, Output relay will be ON whenever
you call this Preset.
Edit Preset Scene
EDIT SCENE - PRESET 1
MOVE TO TARGET POSITION
[NEAR:SELECT/ FAR:CANCEL]
0/0/x1/N
① Using Joystick, move camera to desired
position.
② By pressing NEAR or ENTER key, save current
PTZ data.
③ Press FAR key to cancel.
•
•
❖
❖