Spectra Logic 2K - Manual (Page 28)

Chapter 3. Configuring the Library
28
Before setting the emulation mode for the library robotics or tape drives, find the
setting you want to use in the table below.
Emulation Mode Switch Setting
Response to the Inquiry Command
Drive DIP
Switch
Setting
a
a. The Drive DIP Switch (default 0) determines the drive emulation and is set electronically by the configuration switch.
Library Inquiry
Drive
Manufacturer Drive
Model
Default—
random access 0 Spectra 215 Sony SDX-300C
SDX-500C
SDX-700C 0
Tape stacker mode—Drive
1 only,
no random access robotics
commands 1 No change
b
b. Values listed "No change" retain the last setting; it may be necessary to set the configuration switch a second time.
No change b No change b No change b
Spectra 10000 library
emulation 2 Spectra 10000 No change b No change b No change b
Exabyte EXB 210 library
emulation 3 Exabyte EXB-210 Exabyte EXB-8900 No change b
HP 9000 Model 700/800
(GSC Controller) emulation A No change b Hewlett Packard C-1533A 13
Quantum DLT-7000 drive
emulation B No change b Quantum DLT-7000 No change b
Custom (AIT-2 only) C No change b Sony SDX-300C No change b
StorageTek 9490 drive
emulation D No change b STK 9490 No change b
Spectra 4000 library emu-
lation E Spectra 4000 No change No change No change b
User-defined emulation F Use the serial cable to change these settings