Spectra Logic 2K - Manual (Page 81)

Appendix B. SCSI Cable and Terminator Requirements
81
SCSI Terminator Requirements
If the library is the last device on the SCSI bus, a terminator must be attached to the
empty SCSI connector on the back of the library.
The SCSI terminator must match the SCSI bus configuration, whether differential, LVD,
or single-ended. Teminators are not included with the library. Termination can be
active or passive on a single-ended SCSI bus, but must be the same at both ends.
Note: For best performance, do not terminate the library internally.
Figure 7-1 Close-up shows a SCSI cable attached to the top connector and a SCSI
terminator attached to the bottom connector.
SCSI cable
(not included)
Terminator
(not included)