Spectra Logic 2K - Manual (Page 40)

Chapter 4. Using the Library
40
Getting Information from the Picker’s LED
The robotic picker’s light-emitting diode (LED), visible through the window of the
library, shines either green or amber. The colored light indicates the status of the
picker. The following table describes the LED operational modes and the information
conveyed by these operating modes.
Mode Information
Green The picker is idle and the library is ready for use; this is the normal operating mode.
Green and Blinking The picker is active and functioning properly.
Amber The library is not ready for use.
Verify that the door is shut and that the library SCSI connection is terminated and is within
specifications; see Appendix B. SCSI Cable and Terminator Requirements.
Amber and Blinking Failure. For example; to indicate a jam condition. Locate the source of the jam to return
the picker to its normal state.
Blinking Amber and Green The library configuration switch has been changed since the last power-up and the library
is changing its configuration (as explained in Chapter 3. Configuring the Library).