Sony MZ-NHF800 - Manual (Page 68)

68
Combining tracks
(Combine)
When you record with analog (line) input,
unnecessary track marks may be recorded
where recording level is low. You can
erase a track mark to combine the tracks
before and after the track mark.
The track numbers will change as follows.
This operation can be done on the
recorder only.
• You cannot erase a track mark on a track that
has been transferred from your computer.
• You cannot erase a track mark on a track that
has been recorded in Hi-MD mode using the
MD Simple Burner software.
• You cannot combine tracks recorded in
different recording mode.
1
While playing the track with the track
mark you want to erase, press X to
pause.
2
Find the track mark by pressing the 5-
way control key towards .
slightly.
For example, to erase the third track
mark, find the beginning of the third
track. “00:00” appears in the display.
“MARK” appears in the display for a
few seconds.
3
Press T MARK to erase the mark.
“MARK OFF” appears in the display.
The track mark is erased and the two
tracks are combined.
z
When a track mark is erased when you combine
two tracks, the recording date and title of the
second track changes to those of the first track.
When you erase a track mark between the two
consecutive tracks that are assigned into
different groups, the second track is re-assigned
into the group containing the first track. In
addition, if you combine a track that is assigned
to a group with a track that is not assigned to a
group (two consecutive tracks), the second
track takes the same registration setting as the
first track.
Notes
1 3 4 2
1 3 2
Erase a track mark
Track numbers decrease
T MARK
5-way control key
(.)
X
Note