Sony MZ-NHF800 - Manual (Page 78)

78
1
Insert a recordable disc into the
recorder.
2
Make connections as follows.
1 Connect the dedicated USB cable to
the recorder and to the computer.
2 Make sure the recorder is stopped
and HOLD is released.
3
Check the connections.
When the connections have been
properly made, “PC – –MD” appears
in the display.
When you unplug the
dedicated USB cable from the
computer or remove the disc
from the recorder
Be sure to remove the recorder or the disc
as follows. If not, damage to the data may
occur.
1
Make sure that “REC” is not
displayed in the display window on
the recorder.
2
Press x on the recorder.
“EJECT DISC OK” appears in the
display.
Depending on the conditions, it may
take some time until “EJECT DISC
OK” appears in the display.
3
Unplug the dedicated USB cable
from the computer or remove the disc
from the recorder.
• If you use the recorder connected to the
computer, it is recommended that you connect
the AC power adaptor or insert a new alkaline
dry battery as a precaution against power
failures, disconnection of the dedicated USB
cable or other unforeseen occurrences. We do
not assure the results should there be a mis-
operation, transfer failures, or destruction of
audio data caused by unforeseen occurrences.
• If you disconnect the dedicated USB cable
from the recorder and want to reconnect it,
make sure to wait at least 2 seconds before
connecting it again.
• Make sure to place the recorder at a stable,
vibration-free place during recording.
• Make sure not to connect the recorder to your
computer during recording or playing.
• The system may malfunction if your computer
changes to system suspend, sleep, or
hibernation mode while connecting to the
recorder. Make sure to disable any changes to
suspend, sleep, or hibernation mode.
• Make sure not to connect the recorder and the
computer through a USB hub.
Computer
To the USB cable
connecting jack
Dedicated
USB cable
To the USB port
Notes