Sony MZ-NHF800 - Manual (Page 90)

90
While using the radio
Symptom Cause/Remedy
The radio does not
operate. • The supplied remote control is connected to other unit than this
recorder. The supplied remote control should be used with this
recorder only.
• After confirming that “NO DISC” has disappeared from the display on
the remote control, press RADIO ON/OFF again on the remote
control.
e flashes in the
display on the
remote control and
the radio does not
operate.
• The alkaline dry battery is used up.
, Replace the battery with a new one (page 17).
While the recorder is connected to the computer
Symptom Cause/Remedy
The recorder is not
recognized by the
computer. • The dedicated USB cable is not firmly connected.
, Connect the dedicated USB cable firmly to the recorder and the
computer.
• A USB hub is used.
, Connect the dedicated USB cable directly to the USB port of the
computer.
• Network communication has failed.
, Disconnect the dedicated USB cable, wait at least 2 seconds, and
then reconnect it. If the recorder is still not recognized, disconnect
the dedicated USB cable, restart the computer, and then connect the
dedicated USB cable again.
Even though the
recorder is
recognized by the
computer, it does
not operate
normally. • A USB hub is used.
, Connect the dedicated USB cable directly to the USB port of the
computer.
• You are using the recorder at a place with vibration.
, Use the recorder at a place with no vibration.
The recorder cannot
be used as a storage
device. • The SonicStage or MD Simple Burner software is active.
, Close the SonicStage or MD Simple Burner software.
• A standard disc is inserted.
, Insert a disc used in Hi-MD mode. Only discs used in Hi-MD mode
can be used as a storage media.
The playing time of
a transferred track is
different from the
time that appears on
your computer
monitor. This is due to a calculation discrepancy between the recorder and the
computer.