Sanyo VCC-WD8575P - Manual (Page 9)

English 8
Installing Lens
You are recommended to use any DC type and CS mounting lens equipped with an auto iris.
Note:
• Apply adapter ring (sold separately) when you use any C mounting lens.
• Use any lens of which length (L: see the figure to the right) of the mounting screw is within 5 mm; otherwise you may fail to
install or damage the lens.
Steps for Installing Lens
Switching Over Type of Auto Iris Lens (DC type is selected by default.)
1
2
Remove the lens mounting cap. Install the lens.
Connect the plug to the Lens Iris
Output Terminal (LENS).
Carefully align the lens mount with
the camera opening, then turn the
lens slowly to install it.
If the plug does
not fit into the
terminal, replace
it with the proper
type.
Plug
1
2
Cover
Inside the cover
Remove the side cover. Attach the side cover.
For VIDEO type lens
DC
VIDEO
A. I.
LENS
Loosen screw with a
Phillips screwdriver.
Select a lens type by using the
switch (A.I. LENS).
DC type
Any lens without amplifier
circuit (also referred to as
“Coil lens” or “Without built-in
EE amplifier”).
Adjust the iris by using LEVEL dial on
the lens side.
(This unit has fixed ALC. Adjusting the
ALC on the lens does not take effect.)
VIDEO type
Any lens with amplifier circuit
(also referred to as “Built-in
EE amplifier”).
L
Connection
.$%A:' 8%% 9&2 )$ EQTGANGUU DQQM  TVR''''և'' ߆ 'ވ''