Warning, Precautions concerning installation location – Sega INITIAL "D" TYPE TWIN. User Manual
Page 11
2
www.seuservice.com
3
www.seuservice.com
2. PRECAUTIONS CONCERNING INSTALLATION LOCATION
This product is an indoor game machine. Do not install it outside. Even indoors,
avoid installing in places mentioned below so as not to cause a fire, electric shock,
injury and or malfunctioning.
Places subject to rain or water leakage, or places subject to high humidity in
the proximity of an indoor swimming pool and or shower, etc.
Places subject to direct sunlight, or places subject to high temperatures in the
proximity of heating units, etc.
Places filled with inflammable gas or vicinity of highly inflammable/volatile
chemicals or hazardous matter.
Dusty places.
Sloped surfaces.
Places subject to any type of violent impact.
Vicinity of anti-disaster facilities such as fire exits and fire extinguishers.
The operating (ambient) temperature range is from 5ºC to 30ºC.
LIMITATIONS OF USAGE REQUIREMENTS
Be sure to check the Electrical Specifications.
Ensure that this product is compatible with the location's power supply, volt-
age and frequency requirements.
A plate describing Electrical Specifications is attached to the product.
Non-compliance with the Electrical Specifications can cause a fire and electric
shock.
This product requires the Breaker and Earth Mechanisms as part of the loca-
tion facilities. Using them in a manner not independent can cause a fire and
electric shock.
Ensure that the indoor wiring for the power supply is rated at 10 A or higher
(AC single phase 100 ~ 120 V area). Non-compliance with the Electrical
Specifications can cause a fire and electric shock.
Be sure to independently use the power supply equipped with the Earth Leak-
age Breaker. Using a power supply without the Earth Leakage Breaker can
cause an outbreak of fire when earth leakage occurs.
Putting many loads on one electrical outlet can cause generation of heat and a
fire
resulting from overload.
When using an extension cord, ensure that the cord is rated at 10 A or higher
(AC 100 ~ 120 V area). Using a cord rated lower than the specified rating can
cause a fire and electric shock.
WARNING!
WARNING!