Sega INITIAL "D" TYPE TWIN. - Manual (Page 72)

64 www.seuservice.com 65 www.seuservice.com
ADJUSTMENT PROCEDURE
11-2 ADJUSTING/REPLACING THE VOLUME
 Loosen the 2 screws that secure the VR Bracket and move the VR Bracket to adjust the angle and
condition of the gear alignment.
 Keeping the handle straight, align the gears so that the direction of the D Cut side of the Volume
Shaft matches that shown in the diagram.
 Tighten the 2 screws and secure the VR Base.
 After making adjustments, use the Volume Setting Screen to set the Volume (refer to 10-3E).
The recommended value for the handle Volume is "80H" when the handle is set straight.
Verify that the value decreases when the handle is rotated to the left and increases when rotated
to the right. Use the Test Mode to view the Volume value (refer to 10-3B).
FIG. 11. 2 a