Sega INITIAL "D" TYPE TWIN. - Manual (Page 75)

66 www.seuservice.com 67 www.seuservice.com
12. SHIFT LEVER
In the Test Mode, if the SHIFT LEVER's SW can not be inputted satisfactorily, replace the
Switch. Apply greasing to the Mechanism's sliding portion once every 3 months.
When performing the above work, remove the Shift Lever Unit.
 Turn the Power SW off.
 Remove the 4 Tamperproof
Screws to lift the Shift Lever
Unit.
 Disconnect the Connector to
remove the Shift Lever Unit.
 When reinstalling, follow the
procedure opposite as when
removing. At this time, ensure
that "DOWN" display appears
on the upper part as shown.
 Before starting to work, ensure that the Power SW is OFF. Failure to observe
this can cause electric shock and short circuit hazards.
 Use care so as not to damage wirings. Damaged wiring can cause electric
shock and short circuit hazards.
12-2 SWITCH REPLACEMENT
 Disconnect the wiring Connector of the
Switch to be replaced.
 Remove the 2 Tapping Screws to replace
the Microswitch.
12-3 GREASING
Apply greasing once in 3 months to the
specified portions.
For spray grease, use NOK KLUBER L
60 or Grease Mate (Part No. 090-0066).
TAMPERPROOF SCREW (4),black
FIG. 12. 1
TAPPING SCREW (2)
M3×16
GREASING
MICROSWITCH 509-5704
FIG. 12. 2
 After reinstalling, be sure to check INPUT TEST in the
test mode. (See 10-3B.)
12-1 REMOVING THE SHIFT LEVER
WARNING!