Sierra Wireless Overdrive - Manual (Page 111)

Settings 103
Setti
ngs
Port Trigger Panel
Some applications require multiple ports open for communication, many of which may be initiated
by a computer on the WAN. Examples of this include video conferencing, VoIP (Internet
telephony), and Internet gaming.
With port triggering, the device monitors outgoing data on specific port numbers (trigger ports).
The device keeps track of the IP address of the computer that sends data on these trigger ports,
so that when incoming data on the Forward ports arrives, the device sends the incoming data to
the same computer.
Before you can use or configure port triggering, you must enable it, as explained in “Enabling Port
Triggering” below.
From the Port Trigger panel of the Router tab of the Advanced Settings window, you can:
●
Enable port triggering for specified protocols and ports. See “Enabling Port Triggering for
Specified Protocols and Ports” below.
●
Remove protocols and ports from the port triggering list. See “Removing Ports From the Port
Triggering List” on page 104.
Enabling Port Triggering
Before you can use or configure Port Triggering, you must enable it.
1. Log in to the home page.
2. Click Advanced settings > Router > Basic .
3. Next to Port Triggering , select Enable .
Enabling Port Triggering for Specified Protocols and Ports
1. Ensure you've enabled port triggering. See “Enabling Port Triggering” (above).
2. Click Advanced settings > Router > Port Trigger .
3. In the last row of the table, in the first Protocol list, click the protocol(s) used by the application
for outgoing traffic (to the Internet, sent through the trigger ports).
4. In the Trigger Ports field, enter the port number(s) used to determine that the application is in
use (that is, specify the port number or range of port numbers that the application uses for
outgoing traffic). (Check the user documentation for the application.)
To specify a range of port numbers, separate the start and end port number with a hyphen.
5. In the second Protocol list, click the protocol(s) used by the application for incoming traffic
(from the Internet).
6. In the Forward Ports field, enter the ports to forward to the computer that triggered the rule
(that is, specify the port number or range of port numbers that the application uses for
incoming traffic). (Check the user documentation for the application.)
7. To specify a range of port numbers, separate the start and end port number with a hyphen.
8. Ensure Enable is selected.