Siemens Unix V4.0 - Manual (Page 134)

Configuring Advanced Server for UNIX Activating Advanced Server for UNIX
Product Manual U7613-J-Z815-6-76
©
S
iem
e
n s N
ix
dor
f
In
fo
rm
at
io
n
s s y s te
m
e A
G
1
9 9 5
P
fad
: D:
\O
7 613
e6
\u
761
3e
.k
05
If an error occurs, Advanced Server for UNIX or the spool system automatically sets the
printer to
disabled . The print job for which the error was detected cannot be backed up; it
must be repeated. All other print jobs remain in the print queue until the error has been
recovered. If the error has been recovered, you can start the associated “spool-out”.
Ê To do this, use xpchange -dev <device> -so ON , for example (for Spool V4.x), or
enable <device> (for AT&T Spool).
5.7 Activating Advanced Server for UNIX
5.7.1 Starting NetBIOS
Manual
You can start the NetBIOS administration process manually with nbrfc start .
Automatic
During installation, a link is set up with rc2.d for starting the NetBIOS administration process
automatically.
5.7.2 Start Advanced Server for UNIX (with NetBIOS)
The following commands are available for starting Advanced Server for UNIX:
– asx start (all processes, including NetBIOS and WINS, if configured)
– net start server (the server only)
– /etc/init.d/ms_srv start (the server only; in the background)
asx start command
The asx start command is used to start Advanced Server for UNIX, the NetBIOS adminis-
tration process nbrfcdaemon and all other processes (e.g. for the services).