Siemens Unix V4.0 User Manual
Page 60
Installing Advanced Server for UNIX
Installing server software (asxserver package)
Product Manual
U7613-J-Z815-6-76
©
S
iem
e
n
s
N
ix
dor
f
In
fo
rm
at
io
n
s
s
y
s
te
m
e
A
G
1
9
9
5
P
fad
: D:
\O
7
613
e6
\u
761
3e
.k
04
Interactive or non-interactive installation
There are two ways to install Advanced Server for UNIX:
1. Select
interactive
if the required data is to be input during installation. This is the recom-
mended installation mode for installations via
cdinst
.
2. Select
non-interactive
if the required data is to be input before installation, but if the
default configuration should not be used. The input entered before installation will be
stored in a response file that can be used for installations with no user interaction. This
installation mode is only used for special configurations and it is not described here.
You can start the
non-interactive
installation with a default configuration. With this instal-
lation type, no further input is required before and during installation. Using this method, the
server is always installed as a primary domain controller in it’s own domain. For further
information, please refer to the section
“Installing with the default configuration”
.
The steps for interactive installation are presented on the following pages.
Normally you will choose this installation.
Output language
The
output language
configuration is used to specify the output language of the UNIX
commands
net
and
elfread
and of the Windows Administrative Tool
EventViewer
.
The
output language
does not affect the builtin names of Advanced Server for UNIX objects
as
domain language
does (see below).
The
output language
has to be specified during all installation types.
Please refer to the chapter entitled
for further information on
how to change the output language after installation.
Interface name of the spooler used by the server
Establish which spooler your system will use and specify this during installation.
Check whether the spooler you are going to specify has been configured in UNIX and is
started.
If the spooler has not been started during installation, you will receive a warning message.
The spooler has to be configured during all installation types.
During installation of the server software, the printer devices
lmxnul
and
lmxnone
are created
for internal use.
These printer devices cannot be deleted and cannot be used for printing from the
UNIX shell.
i