Sanyo CH1852 - Manual (Page 80)

Remote Control Unit (continued)
MODE selector button
Green or red (AUTO)
Red (HEAT)
Orange (DRY)
Green (COOL)
Use this button to select the AUTO, HEAT, DRY and COOL mode.
: When this setting is selected, the air conditioner calculates the
difference between the thermostat setting and the room
temperature and automatically switches to the “COOL” or
“HEAT” mode as appropriate.
: The air conditioner makes the room warmer.
: The air conditioner reduces the humidity in the room.
: The air conditioner makes the room cooler.
FLAP button Press this button either to select to set the airflow direction to one of
the six possible positions manually, or to select the sweep function,
which moves the flap up and down automatically.
: The airflow direction can be set manually. (six positions)
: The flap moves up and down automatically.
NOTE
To switch to the sweep function ( ) when in the manual ( ) mode,
hold down the FLAP button.
FAN SPEED selector
button
: The air conditioner automatically decides the fan speed.
: High fan speed
: Medium fan speed
: Low fan speed
1 HR. TIMER button
(1-hour off timer)
1 HR. : When you press this button, regardless of whether the unit is
operating or stopped, the unit operates for one hour and then
shuts down.
ACL button (All clear) Puts the remote control unit into pre-operation status. Always press
this button after replacing the batteries.
SET button After using the TIMER ON button or TIMER OFF button to set the timer,
press this button to activate the new setting.
CANCEL button Press this button to cancel the current timer setting.
9
OI-202-11EG
oi202000
ADDRESS switch The address switch changes to prevent mixing of signals from remote
control units when two Sanyo air conditioners are installed next to
each other. Normally, the address switch is set to A. When switching
the address, the remote control unit must be changed to B. For more
information, please contact the dealer where you made the purchase.