Standard Horizon MATRIX GX3000S - Manual (Page 13)

Page 13 GX3000S
8.7 CHANGING COG TO TRUE OR MAGNETIC
Allows customizing the NAV data showing GPS Course Over Ground (COG).
Factory default is True however following the steps below the COG can be
changed to Magnetic.
1. Press and hold down the [CALL(MENU)] key until
“ Radio Setup ” menu appears.
2. Press the [ENT] key, then select “ Magnetic ” with the
CHANNEL selector knob.
3. Press the [ENT] key.
4. Turn the CHANNEL selector knob to select “
On ” (rep-
resenting “Magnetic”) or “ Off ” (representing “True”).
5. Press the [ENT] key to store the selected setting.
6. Turn the CHANNEL selector knob to select “
Exit ,”
then press the [ENT] key to return to the “ Radio
Setup ” menu, select “ Exit ” and press the [ENT] key
to return to radio operation.
8.6 CHANGING THE TIME LOCATION
Sets the radio to show UTC time or local time with the offset inputted in section
8.5 Changing the GPS Time.
1. Press and hold down the [CALL(MENU)] key until
“ Radio Setup ” menu appears.
2. Press the [ENT] key, then select “ Time Disp ” in the
“ Radio Setup ” menu with the CHANNEL selector
knob.
3. Press the [ENT] key.
4. Turn the CHANNEL selector knob to select “
UTC ” or
“ Local .”
5. Press the [ENT] key to store the selected setting.
6. To exit this menu and return to radio operation mode
press the [16/9] key.
In the local time mode, the display shows the time by the 12-hour system.
Meanwhile, the display shows the time by the 24-hour system in the UTC mode.
(“LOCAL” mode) (“UTC” mode)