Standard Horizon MATRIX GX3000S - Manual (Page 56)

GX3000S Page 56
11.9 POSITION SEND
The feature is similar to Position Request, however instead of requesting a
position of another vessel this function allows you to send your position to an-
other vessel. Your vessel must have an operating GPS receiver connected for
the GX3000S to send the position.
11.9.1 Setting up a Position Send Ringer
The GX3000S has the capability to turn off the Position Send ringer.
1. Press and hold down the [CALL(MENU)] key until
“ Radio Setup ” menu appears.
2. Turn the CHANNEL selector knob to select “ DSC
Setup ” menu.
3. Press the [ENT] key, then select “ DSC Beep ” with
the CHANNEL selector knob.
4. Press the [ENT] key.
5. Turn the CHANNEL selector knob to select “
POS
Send .”
6. Turn the CHANNEL selector knob to select “ Off .”
7. Press the [ENT] key to store the selected setting.
8. To exit this menu and return to radio operation mode
press the [16/9] key.
If you wish to return to enabling the ringer tone, just re-
peat the above procedure, turning the CHANNEL selec-
tor knob to select “
On ” in step “6” above.
11.9.2 Transmitting a DSC Position Send Call
Pre-Programmable Calling
1. Press the [CALL(MENU)] key.
The “ DSC Operation ” menu will
appear in the display.
2. Turn the CHANNEL selector
knob to select the “ POS Send .”
3. Press the [ENT] key to select the Individual directory.
4. Turn the CHANNEL selector knob to select a name
in the directory, then press the [ENT] key.
5. Press the [ENT] key to send your position to the se-
lected vessel.