Standard Horizon MATRIX GX3000S - Manual (Page 76)

GX3000S Page 76
KEYPAD
[1(DIM)] key
When in radio mode, this key is used to directly select channel digit “1” in
a channel number.
Secondary use
Press the [F] key first then press the [1(DIM)] key to access the LCD
Dimmer menu. Refer to section “12.1 LAMP ADJUSTING” for details.
[2(MEM)] Key
When in radio mode, this key is used to directly select channel digit “2” in
a channel number.
Secondary use
Press the [F] key first then press the [2(MEM)] key, memorize the se-
lected channel into the transceiver scan memory for scanning. When
repeat the same procedures ([F]
[2(MEM)]), will delete the channel
from the scan memory. Refer to section “10.12 SCANNING” for details.
[3(SCAN)] Key
When in radio mode, this key is used to directly select channel digit “3” in
a channel number.
Secondary use
Press the [F] key first then press the [3(SCAN)] key to start and stop the
scanning of programmed channels. Refer to section “10.12 SCANNING”
for details.
[4(DW)] Key
When in radio mode, this key is used to directly select channel digit “4” in
a channel number.
Secondary use
Press the [F] key first then press the [4(DW)] key to scan for voice com-
munications on the priority channel and another selected channel until a
signal is received on either channel (Dual Watch). Refer to section “10.11
DUAL WATCH (TO PRIORITY CHANNEL)” for details.
[5(IC)] Key
When in radio mode, this key is used to directly select channel digit “5” in
a channel number.
Secondary use
Press the [F] key then press the [5(IC)] key to activate intercom function
between RAM+(s) or VH-310 handset(s).
Refer to section “14.3 INTERCOM OPERATION” for details.