Saleen 10-8002-C11670C - Manual (Page 10)

10
IV Ballast Installation
Part Number Descriptions Qty
00-9011-C11360* SCREW, BUTTON HD SOCKET CAP SCREW, 18-8 SS, 10-32X1.25" 5
00-9003-C11359* LOCKNUT, NYLON 18-8 SS, 10-32 5
06-1202-C11361A SPACER, BALLAST 1/2" PLASTIC 2
06-1202-C11362A SPACER, BALLAST .75" PLASTIC 3
Tools needed
• ¼ ” drive 1/8” Alan socket
• ¼” drive 3/8” deep socket
• ¼” drive 10 mm shallow socket
• 8” Extension, ¼” drive
• ¼” drive ratchet
• Panel puller
• Drill
• Drill bit ¼”
• Drill bit 1/8”
1. Remove the fender liners. Figure 1 is
an over view where the push screws are
located. Figures 2 and 3 are close ups.
Use the panel puller to remove push
screws.
Figure 1
Figure 2
Figure 3