Saleen 10-8002-C11670C - Manual (Page 12)

12
3. Remove the cover that is attached to
the ballast. It sets flush against the
fender wall to prevent any rattling.
Align the spacers in the proper
locations (P/N 00-1202-C11362*, and
00-1202-C11361*) then fasten the
ballast down using part numbers 00-
9003-C11359*, and 00-9011-C11360*.
Figure 5 shows the ballast in the proper
location. Figure 6 shows the mounting
locations for the hardware. Make sure
the locknut is facing the headlamp. If it
is reversed the screw will push against
the fender liner.
4. The left side (driver side) is done in
the same way as the passenger side
except the ballast is flipped, and there
are only two fastening points. See
figure 7 and 8. Figure 7 shows the
result and figure 8 shows the two
fastening points and orientation of the
ballast.
Figure 5
Figure 6
Figure 7
Figure 8
Make sure the tabs line up with the
Christmas tree.
Groove