Saleen 10-8002-C11670C - Manual (Page 9)

9
III Stock Headlamp Removal
Tools needed:
• Air ratchet or drive ratchet, ¼” drive
• 10 mm shallow socket, ¼” drive
• 8” extension, ¼” drive
• Foam tape
Figure 1
1. Tape off the corners of the
bodywork so it doesn’t scratch the
lens during installation. Leave tape
on until new headlamps are fastened.
2. Remove three screws, 1 on the top
and 2 on the bottom (Figure 1) of the
stock headlampusing a 10 mm
shallow socket with a ¼” air ratchet
or drive ratchet. See figure 2 & 3 for
a close up. Make sure to keep the
hardware it will be reused.
3.Using the panel puller remove push
screw from the top of the headlight
next to screw. There is one on each
headlamp. (Figure 2) Make sure to
keep the push screw it will be
reused.
4. Unclip wiring harness from back
of headlight. Make sure to cap off
the passengers side plug from the
main harness. The connector on the
driver side will plug into the new
wire harness.
Figure 2
Figure 3
Pushpin
Screw