Saleen 10-8002-C11670C - Manual (Page 5)

5
I Front Fascia Removal
1. Keep all hardware you remove.
2. Starting on the left side of the car
remove the three screws from each
wheel well using the ¼” air ratchet
with the short Phillips #2 socket.
See figure 1 for location of screws.
NOTE: Be sure to keep the Phillips
head screws, as they will be reused
when installing.
3. Once the screws are removed, pull
the fender liner out enough (see
figure 2) to insert a 10 mm shallow
wobbly socket on an 8” extension.
Use the ¼” air ratchet or drive
ratchet to loosen the two hex swivel
nuts. NOTE: Make sure to keep
the hex swivel nuts because they
will be used when installing the
new fascia. Figure 3 is a different
view of figure 2 with the bolts
removed.
Figure 2
Figure 3
Tools need:
• ¼” air ratchet, or drive ratchet
• 5.5 mm shallow socket, ¼” drive
• Short Phillips #2 head socket, ¼” drive
• 10 mm shallow wobbly socket, ¼” drive
• 8” extension, ¼” drive
Figure 1