Saleen 10-8002-C11670C - Manual (Page 17)

17
VI Headlamp Alignment
Tools needed
• Phillips head screw driver
10” long shaft
1. Park the vehicle 25ft from a flat white
aiming wall on a flat level surface.
2. Ensure the wall makes a 90-degree
angle with the floor and the car is
facing the wall.
3. Measure the vertical distance from
ground to the center of the HID bulb.
4. Mark a horizontal line on the aiming
wall at the same height as the center of
the bulb (Figure 2).
5. Turn the vertical adjuster knob (Figure
1) until the top of the beam pattern (the
“cut-off”), is just below the horizontal
line drawn in step 4 (Figure 2). The
vehicle adjustor knob is located on the
back of the headlamp. See figure 1.
6. The headlamps are now properly
aimed.
Figure 1
Figure 2