Saleen 10-8002-C11670C - Manual (Page 15)

15
4. Use an existing screw in the body
(Figure 5a) to fasten the relays. Use
the 10 mm socket with the 8”
extension to remove the screw. A
new screw will be used to fasten
down the relays. Connect the relay
housing by the, inter locking system
then unplug the circuits. Fasten
down the relay housing using P/N 00-
9001-C07636*, and then reconnect
the relay.
5. Figure 5b shows the fuses. Use P/N
069-310 to attach the fuses. First
make a pilot using a 1/8” drill bit.
Line up the fuses and fasten them
down.
6. See Figure 6 for attachment of the
wire harness to the ballasts, and
headlamp.
7. Zip-tie the new harness to the stock
harness. Follow each curve (figure
7). Make sure to cut all zip ties flush
to the fastening side.
Figure 5a
Figure 5b
5a 5b
5a close up