Chapter 2, Tgm-hdc, Installation manual – Sunfire TGM-100C User Manual
Page 21: Rear view, Power supply on/off switch (x2), Power supply fan (x2), Power supply status leds (x2), Ethernet port - console, Ethernet port - 1, Ethernet port - 2
19
Installation Manual
CHAPTER 2
TGM-HDC
1
2
3
4
5
6
7
8
9
11
11
1
3
2
10
10
10
TGM-HDC
Rear View
1
POWER SUPPLY ON/OFF SWITCH (X2)
This switch turns the TGM-HDC's Power Supplies On and Off.
There are two switches that must both be switched On or Off for
the unit to function properly.
2
POWER SUPPLY FAN (X2)
These fans keep the Power Supply within the required tempera-
ture range.
3
POWER SUPPLY STATUS LEDS (X2)
These LEDS indicate the status of the Power Supply.
Solid Green=OK
Blinking=Problem Detected
Solid Red=Failure
4
ETHERNET PORT - CONSOLE
This port is used for managing settings on the TGM-HDC.
5
ETHERNET PORT - 1
This port is used for data streaming to TGM-100s and
TGM-100Cs.
6
ETHERNET PORT - 2
This port is not currently used.
7
RS-232 PORT - MODEM
This port connects to the U.P.S. Use the cable that is supplied
with the U.P.S.
8
RS-232 PORT - CONSOLE
This port has no current function.
9
POWER SWITCH-MAIN
The Main Power Switch turns the entire unit On and Off.
10
SYSTEM FAN (X3)
These fans provide cooling to the hard Disc Drives.
11
AC POWER CONNECTOR (X2)
The TGM-HDC has two power cords that must be connected to
the system's UPS.