Sunfire TGM-100C - Manual (Page 9)

7
Installation Manual
CHAPTER 1
TGM-100
Rear View
1 2 3 4 5 6
14 13 11 12 9 8 7 10
1
HDMI VIDEO
Use the HDMI connector to connect your TGM-100 to a digital
fl at-panel television or projector. HDMI Output is usually connect-
ed to the main television used for viewing movies in your home.
To take advantage of the Surround Sound Audio Format, it is
necessary to connect the audio output to a device capable of
decoding the surround sound signal.
• If your digital TV can decode the signal, simply connect it to the
HDMI socket on the back of the TGM-100.
• If your digital TV does not decode the signal, noise will be emit-
ted by the TV’s speakers. In this case you should mute the TV’s
volume and connect an amplifi er with this capability to the digital
output (
9 or 10 ) of the TGM-100.
2 DVI VIDEO
Connect to TGM-DVC DVI to Composite Video Converter to view
video on a Touch panel Controller or TV/Monitor w/ a DVI input.
3
ESATA
Use this socket to connect a Sunfi re eSATA drive.
4 COMPONENT VIDEO OUT
Connect the Y, P
B
and P
R
Component Video Out of the Media-
Server to the Y, P
B
and P
R
COMPONENT VIDEO IN of a suitable
TV to display the TV User Interface. You may also need to switch
the TV to the relevant AUX input to display the picture.
5
COMPOSITE VIDEO OUT
Connect the composite Video Out of the TGM-100 to the com-
posite input of a suitable PAL or NTSC TV to display the TV User
Interface. You may also need to switch the TV to the relevant AUX
input to display the picture.
6
S-VIDEO OUT
Connect the S-VIDEO output of the TGM-100 to the S-VIDEO
input of a suitable PAL or NTSC TV to display the TV User Inter-
face. You may also need to switch the TV to the relevant AUX
input to display the picture.
7
ANALOG AUDIO OUT
This analog audio output should be connected to the input jacks
of a pre-amplifi er, receiver or whole-house controller.
8
IR INPUT
The IR INPUT connection allows remote control information to be
carried from other devices directly into the TGM-100.
9
COAXIAL DIGITAL AUDIO OUT
By connecting the coaxial jack to a digital audio component (D/A
converter, A/V amplifi er etc.), digital signals from the TGM-100
can be transmitted directly from the system without fi rst being con-
verted to analog. This output may not be used for making a digital
copy of your media.
10 OPTICAL DIGITAL AUDIO OUT
The digital optical output can be used to transmit high quality
audio to a device with a digital optical input (D/A converter, A/V
amplifi er etc.) using an optical fi ber cable. The advantage of using
the optical output is that it has low signal loss and is completely
isolated from the ground loop.This output may not be used for
making a digital copy of your media.
11 LAN (ETHERNET) PORT
The Ethernet port is used to connect the TGM-100 to a Gigabit
Ethernet network or high speed Internet connection.
12
USB PORT
Allows the TGM-100 to communicate with supported USB
devices.
13 RS-232 PORT
For use w/ third-party control systems.
14
POWER CONNECTOR
Connect the supplied power cord to this connector to provide
power to the unit.