Samsung 5400 - Manual (Page 57)

|
Handbook 57
Incoming Call Parameters
Ring Response: User Function 11
This function controls how long your fax machine waits
before answering an incoming telephone call. The available
settings are 1 RING (default), 5 SECONDS, 10 SECONDS, 15
SECONDS, or 20 SECONDS.
! At the default 1-ring setting, your fax machine answers
calls immediately, and you will not hear any ring. If you
need to hear the ring, change to one of the other
settings.
Incoming Ring: User Function 16
This function controls the telephone ringing sound your fax
machine makes when a call comes in. When set to off, it does
not ring during incoming calls. The available settings are:
• ON (default): Only rings when set to Manual Receive
[TEL] mode or when the RING RESPONSE function is set
to 5, 10, or 20 seconds.
• OFF: Does not ring when a call comes in.
• DRC (distinctive ring cancel): Rings for each incoming
call with the same tone, even if you have set function
setting 12, DISTINCTIVE RING to on.
Distinctive Ring: User Function 12
Some telephone carriers offer a service called Distinctive
Ring. Distinctive Ring lets you have different numbers on
one line, each with its own distinctive ring. You can then
use one number exclusively as a fax number without the
expense of a second line. (Your local telephone carrier can
provide you with more information about this service,
which usually has an additional charge.) To use this
function, refer to Setting Your Fax Machine’s Ring Pattern
below. Available settings are OFF (default) and ON.
! You must have your local telephone carrier’s Distinctive
Ring service.Your fax machine must be in FAX or PC
answer mode, and the PBX dial parameter must be set
to OFF. Other modes—TEL, TEL/FAX, or TAD—will
override Distinctive Ring.This feature may not work
properly if you have a telephone other than a genuine
Oki optional handset connected to your fax machine.