Strong Enterprises SRT 60 - Manual (Page 11)

8
1. Power On/Standby (Switch to ON/STANDBY mode)
2. Numeric entry (Enter numeric values and to select the channel directly by
entering it’s number)
3. FAV (Open up Favourite list)
4. SAT (Open Satellite list)
5. EPG (Open up Electronic Program Guide menu)
6. EXIT (Exit from menu)
7. RED (information onscreen when to use)
8. GREEN (information onscreen when to use)
9. YELLOW (to activate Subtitle)
10. BLUE (information onscreen when to use)
11. MENU (Open up menu)
12. CHp/CHq select channels or UP/DOWN navigation in menu
13. VOL- or VOL+ to adjust sound or LEFT/RIGHT navigation in menu
14. OK to enter the selected
15. MUTE
16. INFO (Press for current channel information)
17. AUDIO (Select audio: Left / Right /Stereo / Mono)
18.
(Page up and down)
19. TV/AV (Switch between Receiver and TV)
20. BACK (switch to previous channel)
21. TV/RADIO (Switch between TV and Radio)
4.0 GETTING STARTED
4.1 Connecting to TV Set and Switching-On
n
Connect the Antenna cable from your dish to the Sat in connector of the receiver.
n
Connect the receiver scart plug to the scart input of your TV set. You can use the enclosed
adapter cable.
n You can switch on your TV, plug in the power adapter and switch on your receiver if you press the
POWER ON/STANDBY button on remote control.
n
If TV set does not turn automatically to the scart input, please select this input with the AV key,
or similar on your TV remote control.
4.2 First Time Installation
Set Up Wizard:
The Installation Wizard will appear on screen when you power on receiver for the first time.
It is recommended that you do first time installation following Installation Wizard step by step. It will help you
easily achieve system configuration and channel installation. If you are advanced user then you can skip wizard
and press the MENU button and set-up channels using User Installation menu described in point 5.4.