Strong Enterprises SRT 60 - Manual (Page 12)

9
4.2.1 Language Selection
Select the language of your choice with Up/Down buttons and press OK to confirm. The SET UP
WIZARD menu will appear. It describes functional buttons that you should use during installation. Once
you read information press OK button to continue.
4.2.2 Satellite Selection
The Installation Wizard preconfigured for easy installation of Astra 19.2°E or Hotbird 13°E. For these
satellites LNB configuration is predefined as Universal LNB connected to the receiver via DiSEqC 1.0 switch
input 1. If your dish is aimed to Astra 19.2°E or Hotbird 13°E then select the corresponded satellite and
follow further installation steps described in point 4.2.3. If your dish is aimed to another satellite or you
have multiple dish installation then select OTHER to proceed to Antenna Setup menu (see point 5.4.1). Set
the correct satellite and press the BLUE button to enter Channel Search menu, where you also can adjust
your antenna to a maximal reception level using the strength and quality info banner (see point 5.4.2).
4.2.3 Scan Mode
After selection of Astra 19.2°E or Hotbird 13°E Scan Mode menu will appear. You can now select one of
the two options: Preinstalled Channels (only preinstalled channels will be installed) or Satellite Scanning
(all free channels from the chosen satellite will be scanned and installed).
4.2.4 Wizard-Antenna Adjustment
After one Scan Mode has been confirmed Wizard-Antenna Adjustment menu will appear. Adjust your dish
position in small steps until the signal strength and quality bars turn green.
Try to reach the maximum possible strength and quality level. Once you are sure the signal cannot be
improved, fix the dish on this position and press OK on your remote control to start the channel search.
After channel search has been finished, the first saved channel will be displayed on screen.
5.0 MAIN MENU
In the Main Page menu you can find Channel Manager, Program Guide, Timer functions, User Installation
and Receiver information.
A short Explanation how you can navigate through the OSD*-Menu.
* On Screen Display
MENU:
This Button opens in TV/Radio Mode the Main Menu.
CH+ / CH-: With these buttons you can navigate Up/Down.
VOL- / VOL+: With these buttons you can navigate Left/Right, or select settings in different submenus.
OK: Pressed in TV/Radio Mode will call up the Channel List. In OSD mode it opens
submenus and confirms the selection.
EXIT: Press it to go one step back in Menu until TV/Radio Mode is achieved.
NOTE: Your settings will always be saved after leaving OSD mode.
NOTE: To navigate in the channel manager additionally to the UP/DOWN buttons can also be
used the VOL+/- and SCOLL UP/DOWN buttons.