Strong Enterprises SRT 60 - Manual (Page 16)

13
activate it by pressing the the yellow SUB button and choose one of the provided languages.
n Screen Format: You can choose between following formats: 4:3, 16:9 and 4:3 Letterbox.
n
Video Output: You can select the output signal at the scart plug between RGB and CVBS.
n
TV Type: To select the video standard: PAL or NTSC.
n
Start On Channel: Press OK button to select the channel which should be shown every time
you switch on the receiver. With the setting to “None” always the last viewed channel will be
displayed when you switch on the receiver.
5.4.4 Software Download via Satellite
Here you can check the availability of software updates and/or install it.
1. Press the MENU button to enter the “Main Page”.
2. Use UP/DOWN buttons to select “User Installation” and press OK.
3. Use UP/DOWN buttons to select “Software Download” and press OK.
4. Select “Auto Mode”
5. Press OK button to upgrade and then the receiver will search for new software.
6. If new software is found you are informed on screen.
7. Press OK to install the new software, your receiver will reboot during this process.
WARNING: DO NOT switch off or remove the power cord during this process.
5.4.5 Parental Lock
Here you can activate two functions: to lock channels and to lock access into the User Installation menu.
1. Enter this Menu with PIN code (Default 0000)
2. Use UP/DOWN and LEFT/RIGHT buttons to select “Parental Lock” to “OFF” or “ON”.
3. Use UP/DOWN and LEFT/RIGHT buttons to select “Install Lock” to “OFF” or “ON”.
4. Use UP/DOWN buttons to select “New Password” (4 digits), to enter a new PIN code.
5. Receiver will go automatic to next step, confirm again “New Password” (4 digits) and press
EXIT button to quit and save settings.
5.4.6 Factory Default
NOTE: If you use this function all channels and settings will be deleted. The receiver will return
to basic factory default settings.
1. Enter this Menu with PIN code (Default 0000).
2. Attention message appears.
3. Here you can cancel and go one step back to main menu, or confirm factory reset to be done.
The receiver will return to factory default settings.
5.5 Receiver Information
Here you will find all the important information regarding the software and hardware of your receiver.