Strong Enterprises SRT 60 - Manual (Page 17)

14
6.0 OPERATION
6.1 Standby/Power button
Press STANDBY/POWER button, to switch ON your receiver.
If you press STANDBY/POWER button again it is set to Standby mode.
6.2 Changing Channels
1. Stepping through the channel list:
To move through the channel list, press the CH- / CH+ (UP/DOWN) keys on the remote control.
2. Selection by on-screen channel list:
Press OK on your remote to select the required channel directly from on screen channel list.
n
Press UP/DOWN buttons to select channel step by step.
n Press buttons to scroll in the channel list in steps of 10 channels.
n Press OK button to switch to the desired channel.
6.3 Volume Control
The volume level of the receiver can be altered with the VOL- / VOL+ (LEFT/RIGHT) buttons on the remote control.
NOTE:
n
The volume level selected will remain set, even when the receiver is turned off and on again,
until it's altered.
n
Press the the MUTE button to silence the sound from the receiver. The sound remains muted
until the MUTE button is pressed again, the VOL- or VOL+ button is pressed, or until the
receiver is turned off and on again.
6.4 Language Selection
n
Press the AUDIO button repeatedly you can select between different languages. If only one
language is broadcasted, the button is without function.
6.5 Audio Mode
n Press the BLUE button repeatedly and you can select between different audio modes – “Left”,
“Right” and “Stereo”.
6.6 Accessing the favourite channels
n
Press FAV button
n
Select one of the favourite list (each pressing of FAV button shows you the next list) and press OK.
6.7 Teletext
n
Press TEXT button to view Teletext.
n
Press EXIT to leave the Teletext.