Strong Enterprises SRT 60 - Manual (Page 18)

15
6.8 Subtitle
n
Press YELLOW “SUB” button to switch on subtitle support.
n
Press EXIT to leave the subtitle function.
6.9 Displaying program information
You can read the current program information if you press the INFO button (or OK button twice) on the
remote control.
n
Press RED button for EPG Details of the running program. The info will disappear after 5 sec.
or after pressing INFO button again.
n
Press GREEN button to show detailed signal information. The info will disappear after 5 sec.
or pressing EXIT button.
6.10 Edit Channel Name
Press INFO (or OK button twice) and then the YELLOW button to enter the submenu where you can edit
the channel name. Keypad Dialog will appear. Enter the new name and press OK to confirm.
6.11 Switching between receiver and TV set
Press TV/AV button on your remote control to switch between receiver and TV set.
Note: When receiver is in standby mode (turned off), TV/AV button will not be active. In standby mode it
will automatically change to TV set.
6.12 Switching between TV and Radio mode
Press TV/RADIO button on your remote control to switch between TV and radio channels.
A.1 TROUBLESHOOTING
In some region, the digital terrestrial signal may be weak. So you’d better use the antenna in which the
booster was built, for watching the weak signal channels.
Problem Possible cause What to do
Standby light not lit on
IR-eye -Power supply unplugged
-
- IR-Eye not well connected or
defective -Connect Power supply
-Check connection of IR-Eye or try
another one
No signal found -Antenna is disconnected
-Antenna is damaged/misaligned
- Out of digital signal area
- Check aerial lead
- Check aerial
- Check with dealer/installer of the SAT
System or call the Support Hotline