Schneider Electric TSXETG100 - Manual (Page 11)

63230-319-211A1 ConneXium ™ Ethernet Gateway
2/2006 Setup
© 2006 Schneider Electric. All Rights Reserved. 11
EN
G
L
IS
H
Web Page Access
Action Result
1. From the Setup page, click Web Page
Access.
Opens the Web Page Access page.
2. In the Ethernet & TCP/IP row, select the
access level (None, Read-only, or Full) that
each user group will have for the Ethernet &
TCP/IP web page.
See Table 6 below for an explanation of access
levels for each group.
3. To allow Guest access to the web page,
select Read-only under the Guest column.
NOTE: If the Guest group is Read-only,
other groups may only be set to Read-only
or Full.
Allows the default Guest group to access the
web page.
4. Repeat steps 2 and 3 for the Serial Port,
Device List, Statistics, and Read Device
Registers rows.
Selects the access level for each web page.
5. Click Apply. Saves the password settings.
Table 6: Group Access
Group Access
Administrator Full access to all web pages
NOTE: We recommend that you change the default administrator
password for system security the first time you log in.
Guest Read-only access to selected web pages.
Three user-defined
groups Choosing from the following options, the administrator assigns web
page access for each group. Access levels are as follows:
• None: a group has no access to selected web page
• Read-only: password grants a group read-only access to the
selected web page
• Full: a group has the same access as the Administrator group to the
selected web page
Figure 9: Web Page Access Page