Schneider Electric TSXETG100 - Manual (Page 3)

63230-319-211A1 ConneXium ™ Ethernet Gateway
2/2006 Accessing the ETG Over a Network
© 2006 Schneider Electric. All Rights Reserved. 3
EN
G
L
IS
H
Additional Resources Documentation and Firmware: Go to www.telemecanique.com, select
Products > Products index > Systems and architectures > Connexium.
ACCESSING THE ETG OVER A
NETWORK After you set up the Ethernet parameters (see the installation guide), you
can access the ETG over an Ethernet LAN using Internet Explorer 6.0 or
higher.
Logging into the ETG
Logging Out We recommend logging out whenever you do not need access to the ETG.
To log out of the ETG configuration session, click Log Out to end your
session.
Action Result
1. Launch Internet Explorer 6.0 or higher. Opens Internet Explorer.
2. In the Address text box, type the address
of your ETG (169.254.0.10 is the default),
then press Enter.
Opens the Login dialog box.
3. Type your user name (Administrator is the
default) and password (Gateway is the
default) into the text boxes, then click OK.
Enters the user name and password, then
opens the ETG home page.
4. Click Setup to access the ETG setup page,
or click Diagnostics to access the ETG
diagnostics page.
Opens the Setup or Diagnostics pages.
Figure 1: The ETG Home Page
Menu bar