Schneider Electric TSXETG100 - Manual (Page 5)

63230-319-211A1 ConneXium ™ Ethernet Gateway
2/2006 Setup
© 2006 Schneider Electric. All Rights Reserved. 5
EN
G
L
IS
H
SETUP To access the Setup web page links, click Setup on the ETG menu bar.
Ethernet and TCP/IP Settings
NOTE: After making changes to the Ethernet parameters and clicking
Apply, the ETG will reboot.
Action Result
1. From the Setup page, click Ethernet &
TCP/IP.
Opens the Ethernet & TCP/IP page.
2. Select your frame format and media type.
Contact your network administrator if you
do not know.
Selects the frame format and media type.
3. Enter your IP address, subnet mask, and
default gateway address assigned to your
ETG by your network administrator.
Enters the Ethernet parameters for the ETG.
NOTE: If you enter an IP address that is used
by another device, you will be prompted to
select a new IP address. See “Duplicate IP
Address Detection” on page 6.
4. Click Apply. Updates the ETG Ethernet and TCP/IP
settings.
* See Table 2 on page 5 for a list of options.
Figure 2: Ethernet & TCP/IP Page
Table 2: ETG Ethernet and TCP/IP Settings
Option Description Setting
Frame Format Used to select the format for data sent over
an Ethernet connection. Ethernet II, 802.3 SNAP
Default: Ethernet II
Media Type Used to define the physical Ethernet
connection or media type. • 10T/100Tx Auto
• 10BaseT-HD
• 10BaseT-FD
• 100BaseTX-HD
• 100BaseTX-FD
Default: 10T/100Tx Auto
IP Address Used to enter the static IP address of the
ETG. 0.0.0.0 to 255.255.255.255
Default: 169.254.0.10
Subnet Mask Used to enter the Ethernet IP subnet mask
address of your network. 0.0.0.0 to 255.255.255.255
Default: 255.255.0.0
Default Gateway Used to enter the gateway (router) IP
address used for wide area network (WAN)
communications. 0.0.0.0 to 255.255.255.255
Default: 0.0.0.0