Sanyo PJ-Net Organizer Plus POA-PN40 - Manual (Page 31)

31
PJ-NET ORGANIZER
OWNER'S MANUAL
ENGLISH
Network configuration
Click Network on the main menu. The following setting page is dis-
played. This page is to set the IP Address, Subnet Mask, Default
Gateway, DNS (Domain Name Server) and projector name.
The IP address and Subnet Mask have been configured already in chapter
"Installation". If you want to change them or configure default gateway or DNS, per-
form them in this page. Enter an applicable address number onto each parameter
and click Set button.
The Network Unit begins restarting and it takes about 20 seconds. Close (Quit) the
web browser and access to the login page again in 20 seconds.
*1 Set [0.0.0.0] if the network does not provide the gateway (router).
*2 Set [0.0.0.0] if you do not use the function E-Mail alert.
*3 If you use the DNS server, register the host name registered to the DNS server as a projector
name. You can access with this projector name from any computers in your network. If you
do not use the DNS server, access with the assigned IP address to the projector.
* All the network setting will reset to the default when setting [0.0.0.0] of the IP Address.
Item Description
IP address .........Sets IP address of the projector
Subnet mask ......Sets Subnet mask. Normally sets 255.255.255.0
Default gateway * 1 ...Sets IP address of the default gateway (Router)
DNS * 2 ................ Sets IP address of the DNS server. Must be set
when using the e-mail function
PJ name * 3 ......... Sets name of the projector. (64 characters maxi-
mum)
✐ You must use the number specified by your administrator.
The address must be entered as a group with four numbers
split by a dot like [192.168.001.101].
Network configuration